From the spatial environment of the punch press, safety facility inspection, performance of each part, process specifications and safety tips design, the following is briefly said preparation before using 30-ton C-type high-speed punch press. The high-speed punch press is a high-speed mechanical equipment. Be familiar with the preparation work before use to effectively improve production efficiency.
Four aspects of preparation before using 30-ton C-type high-speed punch press.
1. Check the spatial environment
Environmental preparation is mainly about hygiene, temperature and the layout of peripheral equipment. Whether the debris on the ground is cleaned up, whether the air is flowing, whether the waste gas precipitation is removed, and the ordinary punch press should be placed in an environment below 38 degrees, because too high an ambient temperature will reduce the performance of electronic components and affect the life of parts; in addition to leaving a certain distance according to the process and the nature of the operation, the punch press equipment should be placed reasonably. Try not to place other machines and equipment that affect the work of the punch press around the punch press, such as other machines with excessive noise, or electrical appliances that interfere with the control system of the punch press.
2. Safety facility inspection
Check the emergency stop button, and make sure it feels smooth when pressed, without any stuck phenomenon, and has a fast response speed. Test the sensitivity of the safety protection device, induction switch, and safety clamp. At the same time, the warning signs of the safety facilities should be clear and easy to identify. The installation of the safety facilities should be firm and the installation position should be reasonable. Applicable equipment: samhoor stainless steel webbing adjustment buckle three-speed buckle clothing adjustment buckle Japanese buckle safety belt anti-slip buckle hardware accessories high-speed precision punch press.
3. Performance inspection of each part
Check the oil tank, check whether the mold is placed accurately, adjust the closing height, ensure that the upper and lower molds are placed firmly without the risk of falling off, guide pillars, copper sleeves, etc. Check whether the screws are loose, whether the clutch is flexible, whether the oil pipe is blocked, whether the stamping accessories are aging, worn and loose, and whether the contact between the switch and the power line is poor. Applicable equipment: samhoor mountaineering shoes crampons anti-slip claws anti-slip buckle claws five-claw nails claw eyelets five-tooth and eight-tooth anti-slip nail claws high-speed precision punch press
4. Familiar with the process and specifications, safety prompt design
Operators should be familiar with the operation process and specifications. Developing habits can reduce operating errors. Employees should check whether they are wearing work clothes, reduce static electricity, wear safety hats and protective gloves, and shoes should have certain anti-scratch functions. Goggles and protective clothing must be worn for special operations to avoid physical injuries to personnel. For some more dangerous operations, prompts can be placed in appropriate locations. Direct prompts can effectively reduce dangerous operations.
Before the equipment is put into operation, effective preparation can reduce stamping errors and avoid wasting energy and metal materials. The above is part of the preparation before using 30-ton C-type high-speed punch press.
