During the punching process, the punch press sometimes bursts the product and gets stuck. What to do if the product is stuck when punching with C-type three-round guide high-speed punch press? A stuck punch press cannot move up and down normally, and cannot move up or down. The stuck punch press usually requires repairs by technicians related to the punch press. We can try to return the punch press by loosening the slider and using tools such as pry bars and wrenches. The screws that can be turned can be used to try to see if the slider can be loosened, and loosen the slider to remove the mold and workpiece. Another way is to use a wrench and pry bar to rewind the flywheel, and then rewind the flywheel to take out the workpiece. Or use a wrench to block the clutch and pry the workpiece.
In the case of the die of the Open C-type three-round guide high-speed precision punch press being stuck, we first turn off the power, prepare the tools and climb the lever, then walk to the side of the step, which may be the right side or the left side. After seeing the hole of the hand-climbing lever, slowly shake the lever with the hand-climbing lever. After shaking to the appropriate position, remove the die of the punch press for repair. Alternatively, we can first loosen some of the screws in front of the punch press by rotating counterclockwise to the right. After the punch is loosened, directly climb the lever and slowly shake it up little by little to check and repair the die of the C-type three-round guide high-speed precision press.
What needs to be paid attention to is that safety issues must be paid attention to when repairing the punch press, and it is best to operate with more than two people. At the same time, we record and analyze why the punch press is stuck. Is it the material or size of the metal raw material unreasonable or the precision of the mold in design is not accurate enough? Or is it that the mold is tilted during the punching process, which will cause the punch press to get stuck? Analyze specific problems specifically and solve the problem of "What to do if the product is stuck when punching with C-type three-round guide high-speed punch press" from the root.